AIC ADV80 52mm CAN Digital Gauge – Made in NZ

Overview

The ADV80 from AI Controls (AIC) is a high-performance CAN digital gauge designed and made in New Zealand to integrate directly with leading aftermarket ECUs. Built in a durable anodised 6061 aluminium housing, this unit delivers real-time engine data, advanced control features, fault monitoring, and full customisation — all in a compact 52mm form factor.

Whether you're tuning, racing, or building a serious street car, this display gives you complete visibility and control over your engine management system.

Key Features

• Anodised 6061 aluminium housing
• 46+ live CAN data channels
• Dual-point oscilloscope view
• Fault code monitoring and clearing
• ECM security access
• Fully adjustable warnings & shift light
• Adjustable units (PSI/Bar/kPa, °C/°F, KM/H/MPH)
• Dim display input & brightness control
• CAN output support

ECU Control Functions (ECM Dependent)

• Adjust boost level
• Adjust traction control
• Enable/disable antilag
• Enable/disable launch control
• Check engine light display

Display Screens

• Boost Gauge
• Dynamic Lambda Gauge
• Tachometer
• Multi-Gauge A, B & C
• User Defined Gauges (x2)
• Fault Code Monitor
• Live Data View (All Channels)
• Oscilloscope
• ECM Control
• Security & Settings

Supported ECUs

• Link Engine Management
• Haltech
• MaxxECU
• Emtron
• Ford Barra
• Hondata
• ECU Masters
• Motorsport Electronics UK
• Megasquirt
• Edelbrock

(Displays only data available from the connected ECU.)

Data Channels Available (ECU Dependent)

The gauge can display a wide range of live CAN data including:

• Boost / Manifold Pressure (with peak tracking)
• Lambda (multiple channels + overall)
• RPM
• Oil Pressure & Temperature
• Coolant Pressure & Temperature
• Fuel Pressure & Temperature
• Injector Duty Cycle & Pulse Width
• Ignition Timing
• Ethanol Content
• Throttle Position
• Gear Position
• Vehicle & Individual Wheel Speeds
• Cam Positions
• Exhaust Gas Temperatures (up to 8 channels)
• Battery Voltage
• ECU Temperature
• And more (46+ total parameters)

Fault codes can also be displayed directly on screen.

Installation & Wiring

Supplied with a pre-terminated 6-pin harness.
Requires 12V nominal DC with 0.5A fused supply.

Wiring:

• Black – Ground
• Red – Ignition 12V
• Orange – Dim Input
• Yellow – CAN High
• Green – CAN Low
• Brown – Not Used

Mounting

• 52mm body fits standard gauge holders
• 2x M3 threaded holes on rear (44mm centre-to-centre) for custom bracket mounting

CAN Setup (Example – Link ECU)

• Load supplied AIC CAN stream
• CAN ID: 1000
• Transmission Rate: 100Hz
• Enable CAN output in ECU software